About this calculator
Count metal roof sheets such as box profile, corrugated or tile-effect, with ridge, verge and eaves trim, foam closures and screws.
How it’s calculated
Panels per side = ceil(eaves length ÷ coverage width). Panel length = slope length + eaves projection. Screws are estimated at about 7 per m².
Worked example
With these inputs:
- Roof length along eaves
- 12 m
- Slope length (eaves to ridge)
- 4.5 m
- Roof sides
- Two (gable)
- Panel coverage width
- 1000 mm
- Extra length at eaves
- 50 mm
the result is:
- Panels needed
- 24 panels
- Panels per side
- 12
- Sheet area
- 109.2 m²
Tips from the trade
- Use the panel’s coverage width, not its overall width. Side laps eat 2–4 inches or 50–100 mm.
- Order panels cut to length. Long panels may need an end lap; check the maker’s minimum overlap for your pitch.
- Fix through the high rib or the flat depending on the profile, following the manufacturer.
- Check the minimum pitch for your sheet profile.
Results are estimates for planning and pricing. Check quantities against your drawings, the manufacturer’s data and the Building Regulations before ordering.